Hydraulic Car Lifts at E.A. Motor Industries Ltd (Micron)
834
Until the 1980s, most vehicle lifts were of the in-ground type. Today, surface mounted lifts are the most widely used. Surface mounted lifts are typically bolted to the garage floor and powered by an electric motor which operates either a hydraulic pump or a screw type drive.
2 Post Surface Mounted
2 post surface mounted lifts are the most popular type of surface mounted lift purchased today. These lifts are usually frame-engaging and have swing arms which travel up the two columns. 2 post lifts are synchronized mechanically, hydraulically or electronically. 2 post lifts make a clicking sound when lifting...it´s the load holding device. To provide support, always lower the lift onto the load-holding-devices.
We at MICRON are dealers in 2 post hydraulic lifts which are available in both single and three phase motor versions.
Uses:
Engineering Workshops
Automobile Garages
Car Wash Centres
Petrol Stations, etc.
Features:
Manual two side release system
Dual hydraulic cylinder drive, stable lifting and lowering
Low noise
Full proof safety rack
Optional 24V power control box considers safety operation
Adopt two steel cables for equalization, makes two carriages to move synchronously
Reverse hand pump joint on hydraulic block for emergency lowering
Dynamically tested with 125% of rated capacity and statistically tested with 150% of rated capacity
Easy Maintenance
Convenient operation
CE certificate
